Book now: 10% off winter work — any electrical job scheduled for December, January or February. Book now: 10% off Dec–Feb Call for a winter price →
Why It Matters Here

Parkville’s outside disconnect rule, and what it means for an upgrade

Parkville changed code books in January 2026, and two of its local amendments reach panel work. The panel job itself is the familiar one: a breaker box with no spaces left, a brand on the label that insurers question, or a 100 amp service now asked to carry central air, an electric range and a car charger. What Parkville adds is a question about where the panel sits in relation to the meter, and a rule for the bedroom circuits that come off it.

Parkville inspects to the 2023 National Electrical Code, adopted by Ordinance 3290 and in effect since January 20, 2026, with local amendments. One of them changes a panel job: the main disconnect has to sit within ten feet of where the service conductors enter the building. A service that runs farther than that needs a disconnect outside.

In practice: if your panel is across the basement or out in the garage, or the new one is going somewhere else, the upgrade usually includes an outside disconnect as well as the panel. We measure the run on the first visit and check it with the city, so it is settled before you see a price, not on inspection day.

The permit is the other local piece. Parkville issues electrical permits only to a licensed master electrician or a contractor who employs one. We are licensed in Parkville, so we pull the permit, book the inspection and meet the inspector. The city is on Evergy, so the meter pull and the reconnect are booked with Evergy, and that appointment usually sets the day. We work across town, from Downtown Parkville to Riss Lake, The National, Parkville Heights, Riverchase and Thousand Oaks, out of our home base in the Northland.

An older Zinsco panel with the cover off, color-coded breakers down the middle and wiring crowding both sides
What we still find. A Zinsco panel with the cover off, its colored breaker handles in one column and the wiring crowded in around them.
A new breaker panel on a plywood wall, service conductors landed on the main breaker and open spaces left below the breakers
What we install. A new panel with the service conductors on the main, the branch circuits landed, and open spaces left below for what comes next.
Customer Reviews

What a Parkville Customer Said, and a Panel Job in Kansas City

“

Brad did an excellent job and was professional. Would definitely use these guys again with any electrical problems I encounter.

Schafer W. Google review · Parkville, MO

Brad is part of our family crew.

“

Came in and upgraded my electrical panel, added a whole home surge protector and ran a new circuit for EV charging. All done in 7 hours

Chris H. Google review · Kansas City, MO · panel upgrade
Warning Signs

Signs a Parkville electrical panel needs repair, replacement or an upgrade

  • A Federal Pacific, Zinsco or Challenger label. Federal Pacific and Zinsco are the two names insurers and buyers’ inspectors ask about first, and Challenger has a record of bus connections that run hot. If one of them is on the door, plan on replacement rather than repair. The old panel brands guide shows what each label looks like.
  • A 100 amp main, or a fuse box. Sized for a house from before central air, an electric range and a dryer all ran at once. When those share a 100 amp service with a new charger or hot tub, the service is the limit, not the breakers.
  • No spaces left in the panel. Tandem breakers squeezed in over the years, or a basement finished on whatever room was left. A sub-panel can be enough when the service has capacity; a load calculation says whether it does.
  • A panel or breakers that have been wet. Downtown Parkville sits in the Missouri River floodplain, and in June 2011 the city sandbagged and put up temporary flood walls. Electrical equipment that has been under water is replaced, not dried out and put back in service, and that includes a basement panel that took on water.
  • Heat, buzzing or a burnt smell at the panel. A connection is loose or overheating. Call the same day rather than waiting for a breaker to trip.
  • A charger, a hot tub or new bedroom circuits are planned. Each new 240 volt load needs room in the panel and capacity in the service. New bedroom circuits in Parkville get arc-fault breakers under the city’s amendment, even in an existing house, so the panel needs room for those as well.
Pricing

What moves the price of an electrical panel upgrade in Parkville

Every job gets a flat price once we have seen it, before any work starts. These are the things that move it, and which way.

What drives the cost of Panel Upgrades in Parkville, MO
JobRelative costWhat drives it
Electrical panel repair Lowest A worn breaker, a burned connection on a lug, two wires sharing one breaker terminal. We find out why it failed before replacing the part.
Same-size panel replacement Baseline A new panel and breakers on the service you already have. The answer for a Federal Pacific, a Zinsco or a full panel when the service behind it is big enough.
100 → 200 amp service upgrade Higher The panel, the meter socket, the service entrance conductors and the grounding, all replaced, with Evergy pulling the meter and reconnecting it.
Outside disconnect on a long service run Add-on Required by Parkville’s amendment when the panel sits more than ten feet from where the service conductors enter the building. We measure it on the first visit, so the quote already says whether you need one.
Sub-panel for a basement, garage or shop Moderate When the service has room and the main panel does not. The length of the feeder sets most of it.
Arc-fault breakers on bedroom circuits Add-on Parkville requires them on new bedroom circuits, including in an existing house. Each one costs more than a standard breaker.
Grounding and bonding Included Ground rods, the water pipe bond and the grounding electrode conductor, checked and brought up to date with every service upgrade.

One flat price after we have seen the panel, the meter, the grounding and the length of the run between the meter and the panel. Evergy’s meter appointment usually decides the day. The electrical panel replacement cost guide lists the ranges we quote and what moves a job within them.

Want the flat number for your house? Call (816) 972-5159 or text us a photo of your panel.

How It Goes

How an electrical panel upgrade goes in Parkville

01

Look at the panel, the meter and the run between them

Brand, main breaker size, spaces left, the grounding, and how far the service conductors travel inside the building before they reach it. In Parkville that last measurement is what the city’s outside disconnect rule turns on.

02

A load calculation, then a recommendation

Repair, same-size replacement, sub-panel or 200 amps. We show you the numbers behind the one we recommend.

03

Parkville permit

Pulled by us as the licensed contractor, and inspected to the 2023 National Electrical Code with Parkville’s amendments. The quote is written to that code.

04

Evergy meter pull

Only Evergy can de-energize the wires at the meter. We book the disconnect and the reconnect and tell you the outage window before the day.

05

Install, label, inspect

The panel and service changed in one visit, every circuit named on the new directory, and we are there when the inspector comes.

FAQ

Questions We Get in Parkville

How much does an electrical panel upgrade cost in Parkville?

Repair costs least, and a same-size replacement comes next. A 100 to 200 amp service upgrade costs more because the meter socket, the service entrance conductors and the grounding are replaced with the panel. In Parkville two things can add to it: an outside disconnect when the service run is longer than ten feet, and arc-fault breakers on any new bedroom circuits. We give one flat number after measuring, and the panel cost guide lists the ranges we quote.

What is Parkville's outside disconnect rule?

A local amendment to the 2023 National Electrical Code: the main disconnect has to be within ten feet of where the service conductors enter the building, and a service that runs farther needs a disconnect outside. It comes up on a panel or service upgrade because that is when the service is rebuilt. If the panel is across the basement or in the garage, or the new one is going somewhere else, plan on one. The 2023 code has its own outdoor emergency disconnect rule for houses as well, so we measure the run and confirm with the city before quoting.

Which electrical code does Parkville inspect to?

The 2023 National Electrical Code, adopted by Ordinance 3290 and in effect since January 20, 2026, with two local amendments that show up on real jobs: the outside disconnect on service runs over ten feet, and arc-fault protection on bedroom circuits, including new circuits added to an existing house. Kansas City is still on the 2017 edition, so a quote written for a Kansas City address can leave out work a Parkville permit requires.

Do you pull electrical permits in Parkville?

Yes. Parkville issues electrical permits only to a licensed master electrician or a contractor who employs one. We are licensed in Parkville, and our master electrician has been licensed since 1997. We pull the permit and meet the city inspector ourselves.

Do I need 200 amps?

If the house runs central air, electric cooking and an electric dryer, or you are adding a car charger, a hot tub or a heat pump, very likely. A house heated with gas and with no new loads planned can be fine on 100 or 150 amps. We run the load calculation and tell you which you are.

My panel was under water. Can it be dried out?

No. Electrical equipment that has been under water is replaced, not dried out and reused. Downtown Parkville is in the Missouri River floodplain, and in June 2011 the city sandbagged and put up temporary flood walls to hold the river back. If water reached your panel, breakers or meter socket, do not switch it back on yourself. Call us and we will tell you what has to be replaced before the power can go back on.

Is a Federal Pacific or Zinsco panel a problem?

Federal Pacific Stab-Lok breakers have a long record of failing to trip, and Zinsco is the other brand insurers and home inspectors flag most. For both we recommend replacement over repair. A photo of the label on the panel door is enough for a first opinion.

Can you add an EV charger circuit while you upgrade the panel?

Yes, and it costs less than coming back for it. Parkville is on Evergy, so the Evergy EV charger rebate can apply if you meet its terms. Our EV charger installation page covers the charger side.

How long will the power be off?

Usually four to eight hours for a panel replacement, set by the window Evergy gives for the meter pull; a full service upgrade runs toward the long end. We tell you the window before the day.

Can you add a generator interlock at the same time?

Yes, for a portable generator: an inlet on the outside wall and an interlock on the new panel, so the main breaker and the generator breaker can never be on together. We do not install standby whole-house generators.

Is a breaker box the same thing as an electrical panel?

Yes. Breaker box, electrical panel and service panel name the same box. Swapping it at the same size is a panel replacement. Raising the amperage is a service upgrade, which replaces the meter socket and the service entrance conductors too, and in Parkville that is when the run from where the service enters the house to the panel gets measured.

Want the flat number for your house?

Call, or text us a photo of your panel. One price for the whole job before work starts.

Call Text Free Quote